![]() ![]() When it reboots, it should now boot into a fully working copy of macOS Mojave.īig thank you & all credit goes to for this tool. This isn’t necessary under most circumstances.ġ1. If for some reason the system fails to work correctly after rebooting, boot back into your installer drive, run the post install patch again, and select “Force Cache Rebuild” before rebooting.It may sit there for a few moments rebuilding caches before rebooting. Select the volume you have just installed macOS Mojave on, and click “Patch.” When it finishes patching, click “Reboot”. You can also select other patches of your choosing.ġ0. The optimal patches will be selected for you based on the model you select. In the application, select the Mac model you are using. This time, open the “macOS Post Install” application.ĩ. When the install completes, reboot back onto the installer drive. Install macOS normally onto the desired volume.Ĩ. A demo of the modified booting process can be viewed here.ħ. It is not quite as clean as native booting, but will not cause any issues while running Mojave. If you decide to use APFS, a custom booting method will be installed by the post-install tool, as the firmware of these unsupported machines does not natively support booting from APFS volumes. I have a Macbook Pro mid 2012 which had worked just fine until I upgraded to Mojave a couple of days ago. If you have a machine that did NOT natively support High Sierra (and therefore cannot boot APFS volumes natively), please note the following:- If you use APFS, you will not have a bootable Recovery partition. MacOS Catalina Patcher (formerly macOS Mojave Patcher, macOS High Sierra Patcher and macOS Sierra Patcher) is a small yet powerful tool that can. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |